Exo Terra Repti Clear F250 - Manual (Page 6)

6
Filter Media
The Exo Terra Repti Clear F250 and F350 Terrarium Filter provides
3-stage filtration. The large foam captures and removes large
particulate matter and debris and enhances biological filtration, the
smaller foam captures smaller, finer particulate matter; and the
carbon cartridge helps improve water clarity, color and smell.
The foam pads will gradually fill with trapped debris and require
rinsing. Re-using the foam can help protect the bacterial colonies
and provide continual biological filtration. Foam pads should be
rinsed at least once a month, more often if necessary.
It is not recommended to rinse the foam directly in tap or well water,
as the water contains chemicals that make it unsafe to reptiles and
amphibians. As a precaution, the foam should always be rinsed
in de-chlorinated water. To do this, fill a container with water and
then treat the water with a water conditioner such as Exo Terra
Aquatize to neutralize the chemicals. Once the water has been
de-chlorinated, you can then rinse the foam. (note: this procedure is
also recommended when replacing with new foam).
Filter media (foam pads, carbon cartridge) should be replaced every
6-8 weeks to ensure proper functioning of the filter, more often if
necessary. Never rinse or replace all filter media at the same time,
alternate rinsing/replacement of filter media.
Replacement Filter Foam and Carbon cartridges can be purchased
from your local Exo Terra dealer or pet retailer.
Troubleshooting:
Caution:
The filter must not be allowed to run dry. If filter fails to operate,
check the following:
No Flow:
• Check if the power supply is on. Check the circuit breaker or
try another outlet to ensure the filter is getting electrical power.
Note: always disconnect the filter from electrical supply before
handling.
• If power supply is working but filter is not, then it may be
clogged by debris. Disconnect the filter, check output spout to
ensure it is not clogged, then follow the maintenance procedures
to clean the impeller.
Low Flow:
• Check the filter’s output spout to ensure it is not clogged by
debris. Then follow the maintenance procedures to clean impeller
• If using tubing, check tubing for sharp bends or blockage
GUARANTEE
This product is guaranteed for defects in material or workmanship
for a period of 2 years from date of purchase. The guarantee is valid
with proof of purchase only. The guarantee is limited to repair or
replacement of the filter only and does not cover consequential loss
or damage of or to animate or inanimate objects. This guarantee
is valid only under normal operating conditions for which the filter