Exo Terra Scorpion Light User Manual

Page 3

Advertising
background image

4

B. Be sure that the voltage of the mains supply corresponds to the

voltage shown on the rating label of the unit.

C. Before connecting to the mains supply ensure that the cord and

the unit are undamaged.

D. WARNING Disconnect the plug of this lighting device and all

other electrical equipment used for the terrarium before placing

your hands in the terrarium and/or performing any maintenance

of any kind.

E. WARNING Whenever installing, removing or maintaining the

Scorpion Light, or any other equipment, always ensure that it is

unplugged.

F. Do not place the light unit near filter outputs or expose it to water

spray or humidity. Do not submerge in water.

Integrated into the Exo Terra

®

Scorpion Light is a self-adhesive

mounting bracket that will allow you to easily attach the unit onto

the terrarium.

1. Clean the outside surface of the terrarium glass.

2. With the protective backing still intact, place the mounting

bracket on the back or the side of the terrarium to determine its

final position.

3. Mark the position with a wax pencil or other marker.

4. Remove the protective backing and carefully fit the mounting

bracket within the marked area.

5. Make sure the tape is pressed evenly against the terrarium glass

and that no air bubbles are showing.

6. Press the adhesive side firmly against the glass panel for at least

30 seconds.

7. Wait a few minutes and make sure the tape is attached firmly to

the terrarium before suspending the fixture.

8. Place the LED Fixture in the mounting bracket and connect the

power supply to the fixture.

9. Simply tap the ON/OFF logo touch button to switch the UV-LED’s

ON. Touch the ONN/OFF logo touch button again to switch OFF.

Maintenance
Warning:

Disconnect the plug of the Scorpion Light, and any other electrical

equipment, used for the terrarium or paludarium before placing your

hands in the enclosure; and/or performing any maintenance of any

kind. Whenever installing, removing or maintaining the Scorpion

Light, or any other equipment, always ensure that it is unplugged.

Cleaning the Unit:

1. The Scorpion Light is not water proof. Do not expose this lighting

device to water spray or humidity. DO NOT SUBMERSE IN WATER

OR ANY OTHER LIQUID.

2. No special maintenance is required for the Exo Terra

®

Scorpion

Light, other than periodic cleaning with a cloth (never use harsh

chemical products or detergents).

3. It is strongly recommended to always follow all the precautions

and procedures outlined in both the Important Safeguards and

Installation Instructions sections.

GUARANTEE

This product is guaranteed for defects in material or workmanship

for a period of 2 years from date of purchase. The guarantee is valid

with proof of purchase only. The guarantee is limited to repair or

replacement of the unit only and does not cover consequential loss

appliance get wet, unplug the appliance immediately.

B. Carefully examine the appliance after installation. It should not

be plugged in if there is water on parts not intended to be wet.

C. Do not operate any appliance if it has a damaged electrical cord

or plug, or if it is malfunctioning or if it is dropped or damaged

in any manner. The power cord of this appliance cannot be

replaced: if the cord is damaged, the appliance should be

discarded. Never cut the cord.

D. To avoid the possibility of the

appliance plug or electrical outlet

getting wet, position the appliance

to one side of a wall mounted

outlet to prevent water from

dripping onto the outlet or plug. A

“drip-loop” should be arranged.

The “drip-loop” is that part of the

cord below the level of the outlet,

or the connector if an extension

cord is used, to prevent water

from traveling along the cord and

coming in contact with the outlet.

If the plug or outlet does get wet,

DO NOT unplug the electrical

cord. Disconnect the fuse or circuit breaker that supplies power

to the appliance, then unplug and examine for presence of water

in the outlet.

3. This appliance is not intended for use by persons (including

children) with significantly impaired physical or mental

capabilities, unless they have been given supervision or

instruction concerning the use of the appliance by a person

responsible for their safety. Children should always be

supervised to ensure that they do not play with the appliance.

4. To avoid injury, do not contact hot parts.

5. Always unplug an appliance from an outlet when not in use,

before putting on or taking off parts, and before cleaning. Never

yank cord to pull plug from outlet. Grasp the plug and pull to

disconnect.

6. Do not use the appliance for other than intended use. The use

of attachments not recommended or sold by the appliance

manufacturer may cause an unsafe condition.

7. Do not install or store the appliance where it will be exposed to

weather or to temperatures below freezing.

8. The safety of this appliance is guaranteed only provided that the

adaptor and light unit are properly installed. Ensure sufficient air

space around the fixture.

9. If an extension cord is necessary, a cord with a proper rating

should be used. A cord rated for less amperes or watts than the

appliance rating may overheat. Care should be taken to arrange

the cord so that it will not be tripped over or pulled.

SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Only close adherence of these installation, electrical and

maintenance guidelines will ensure the safe and efficient use of

this appliance.

Exo Terra

®

Scorpion Light Installation Instructions

CAUTION:

A. The Exo Terra

®

Scorpion Light is for indoor, household use only.

ENGLISH

FRANÇAIS

DEUTSCH

ESP

AÑOL

IT

ALIANO

NEDERLANDS

Advertising