Operation and service information, Notice – E-Z-GO FREEDOM RXV 2+2 User Manual

Page 46

Advertising
background image

Page 26

OPERATION AND SERVICE INFORMATION

Owner’s Guide

Read all of manual to become familiar with this vehicle. Pay attention to all NOTICES, CAUTIONS, WARNINGS and DANGERS.

B

To prevent battery explosion that could result

in severe personal injury or death, never insert

a metal thermometer into a battery. Use a

hydrometer with a built in thermometer that is

designed for testing batteries.

Specific gravity is the measurement of a liquid that is

compared to a baseline. The baseline is water which is

assigned a base number of 1.000. The concentration of

sulfuric acid to water in a new golf car battery is 1.280

which means that the electrolyte weighs 1.280 times the

weight of the same volume of water. A fully charged bat-

tery will test at 1.275 - 1.280 while a discharged battery

will read in the 1.140 range.

Do not perform a hydrometer test on a battery that has just

been watered. The battery must go through at least one

charge and discharge cycle in order to permit the water to ade-

quately mix with the electrolyte.

The temperature of the

electrolyte is important since

the hydrometer reading must be corrected to 80° F (27°

C). High quality hydrometers are equipped with an inter-

nal thermometer that will measure the temperature of

the electrolyte and will include a conversion scale to

correct the float reading. It is important to recognize that

the electrolyte temperature is significantly different from

the ambient temperature if the vehicle has been operat-

ed.

USING A HYDROMETER

1. Draw electrolyte into the hydrometer several times to

permit the thermometer to adjust to the electrolyte

temperature and note the reading. Examine the color

of the electrolyte. A brown or gray coloration indicates

a problem with the battery and is a sign that the bat-

tery is nearing the end of its life.

2. Draw the minimum quantity of electrolyte into the hy-

drometer to permit the float to float freely without con-

tacting the top or bottom of the cylinder.

3. Hold the hydrometer in a vertical position at eye level

and note the reading where the electrolyte meets the

scale on the float.

4. Add or subtract four points (.004) to the reading for ev-

ery 10° F (6° C) the electrolyte temperature is above

or below 80° F (27° C). Adjust the reading to conform

with the electrolyte temperature, e.g., if the reading in-

dicates a specific gravity of 1.250 and the electrolyte

temperature is 90° F (32° C),

add four points (.004) to

the 1.250 which gives a corrected reading of 1.254.

Similarly if the temperature was 70° F (21° C),

sub-

tract four points (.004) from the 1.250 to give a cor-

rected reading of 1.246.

5. Test each cell and note the readings (corrected to 80°

F or 27° C). A variation of fifty points between any two

cell readings (example 1.250 - 1.200) indicates a

problem with the low reading cell(s).

As a battery ages the specific gravity of the electrolyte

will decrease at full charge. This is not a reason to re-

place the battery providing all cells are within fifty points

of each other.
Since the hydrometer test is in response to a vehicle ex-

hibiting a performance problem , the vehicle should be

recharged and the test repeated. If the results indicate a

weak cell, the battery or batteries should be removed

and replaced with a good battery of the same brand,

type and approximate age.

Fig. 32 Hydrometer Temperature Correction

NOTICE

Advertising
This manual is related to the following products: