Gryphon Mephisto Solo - Manual (Page 17)

L bias for idling, you must use
the stand-by switch on the front
panel. Remember, the Green
bias system is not in the signal
path and has only reference to
the preamplifiers microprocess
that is entirely outside the signal-
path.
The Mephisto responds to pre-
programmed switching points at
the volume control, based on our
experience with most speakers.
It is however, possible to lower
the switching positions if you
have efficient speakers or if you
wish to play at 100% Class A
even at low playback levels.
Please refer to the preamplifier´s
manual for further information
about this.
If you remove the link between
the Mephisto and the preamplifi-
er, the amplifier will automatical-
ly revert to manual operation
only.
Rear Panel Functions
Speaker terminals
The binding posts are custom
designed by Gryphon. The spe-
cial design will provide a tight
reliable connection to: plugs,
lugs or bare wire. Do not use
tools or excessive force when
tightening the terminals.
Link in is automatic switching
the Mephisto on when connect-
ed to a unit with same feature
and protocol.
Link out is automatic switching
other units on from the Mephisto
Balanced Input.
The Mephisto provides only bal-
anced input. There are no deteri-
orating phono sockets in parallel
with the balanced input.
The Mephisto balanced inputs
are made to AES standards:
Pin # 1 Shield
Pin # 2 Positive
Pin # 3 Negative
BIAS
Connection for Green bias link
between compatible Gryphon
preamplifier´s and the Mephisto
The Mephisto
protection System
Gryphon has designed a unique
comprehensive system with no
circuit breakers in the signal
path. The “smart” Gryphon pro-
tection system constantly moni-
tors the amplifier by checking 10
times per sec. when the amplifi-
er is on.
DC & HF:
When DC or HF from the source
component is detected, or du to
an internal problem, the
17
checking the amplifier 10
times every second