Gryphon Pendragon User Manual
Page 17
Master tower control.
Adjustments applies to both towers automatically.
Warning:
Be aware that there is 1000 watt amplifier in each tower that
can deliver a huge output in very low frequencies if instruc-
tions are not observed. Please be very careful when handling
this system
Vol+/Vol-
Bass level up or down.
Q+/Q-
Optimizing bass performance to the specific room.
Low cut
Use this with turntable use to prevent overloading the system
with low level noise from turntable ( rumble) or to prevent di-
sasters with a dropped tone arm
MUTE
Always if you change cables – or turn the towers off.
In & out puts
XLR in
Connect to balanced output from balanced preamplifier XLR -
AES standard- ( pin 2 positive, Pin 3 negative, Pin 1 shield )
XLR out
Can be used to loop to Mid/Hi amplifier if preamplifier do not
have 2 outputs.
XLR/RCA
Toggle Switch between balanced or single ended connection
CONNECT ONLY PENDRAGON TOWER TO PREAMPLIFIERS
WITH ABSOLUTELY STABLE DC OPERATION. NEVER TURN
PREAMPLIFIER ON OR OFF OR MOVE TOWER UNLESS THE
PENDRAGON MASTER IS TURNED OFF.
RCA/in
Connect to single ended output from preamplifier
RCA out
Can be used to loop to the Mid/Hi amplifier if your preampli-
fier do not have 2 sets of outputs.