Hall Research USB-EDID-PRO2 - Manual (Page 4)

2
User’s Manual
2
2. Using the Software
2.1. General
In most installations the use of the software is not needed as most functions
can be performed using the push-buttons as described in the users manual.
You can use the software to import/export EDID files from the device. Custom
EDID data can also be written to devices connected to the output if they
support that function.
You can connect more than one VR-DVI to the PC (using several USB ports of
the PC). The same instance of the software detects all connected devices and
allows control from the same interface.
2.2. USB Device Detection
The EMX-DVI software uses standard Windows® drivers to automatically
configure the USB port after connection and does not require any special USB
drivers to be installed.
The first time you connect the extender to the PC, you may experience a short
delay and a windows notification pop-up message may be shown.
2.2.1. The software scans the EMX-DVI settings continuously in real time, so
all changes are immediately reflected on the screen.
2.2.2. If no EMX-DVI device is attached to the system,
the on-screen fields are disabled (grayed out)
2.2.3. Only one instance of the GUI program can run at a
time. Executing the application more than once will
result in an error message.
This detection and auto installation only occurs once. Thereafter, reconnected
devices are detected with no delay or message.