Hall Research UH-1BTX-S - Manual (Page 7)

Mini-Cat® Brand HDMI™ Extender
5
Figure 3 – Locking HDMI Cable
 Connect the HDMI connector labeled OUTPUT to the sink device (HDTV,
Projector, etc)
 Using a Cat5e or Cat6 cable, connect the RJ45 connectors from the Sender
to the Receiver.
 Plug in the power supplies at the receiver and at the sender
3. LED Indicators
Figure 4 – LED Locations
PWR Power. Indicates unit is powered
ACTIVITY Firmware Running. Blinking means device firmware is running properly
LINK UTP Link. Solid on means Sender & Receiver are communicating
HDCP Video Status. Off = No Video, Blink = Video, Solid ON = Video + HDCP
Twisted Pair Cable Recommendations
Distance Cable Type Gauge
0 to 199 ft Cat5e, Cat6, Augmented Cat6 24, 23
UH-1BT
200 to 230 ft Cat6, Augmented Cat6 23
Distance Cable Type Gauge
0 to 299 ft Cat5e, Cat6, Augmented Cat6 24, 23
UH-1BTX
300 to 330 ft Cat6, Augmented Cat6 23
Note:
 If the CATx cable is ran adjacent to or near interfering electrical sources
such as ballasts, generators, motors, etc, then Shielded Twisted Pair (STP)
would be preferred instead of UTP