Hall Research VSM-I-A-4-JA4 - Manual (Page 3)

3
Hall Research DS Manager
3. Configuration
3.1 Ethernet Configuration
If the configuration of the end users LAN is compatible with the default
settings, then the user is not required to make changes to the Ethernet
Configuration.
If the configuration is not compatible, use the DS Manager to change the
unit’s configuration.
Set the IP Address to any STATIC unused address available on the end-
users network.
The IP Address of the model must be in the same subnet as any computer
attempting to access the device. If the computer attempting to access the
device is on another network subnet, then the end-user is responsible for
configuring any network routers or switches necessary to allow access to
the devices IP Address on Ports 23 and 1001. Contact your network IT
administrator for assistance with these settings.
Set the Gateway Address to the required IP Address of the end-users
Gateway. If the end-user will always access the device from a computer
connected on the same network node, then the Gateway Address may be
left at its default value. Contact your network IT administrator for
assistance with these settings.
Set the Net Mask to the required values compatible with the end-users
network. If the end-user will always access the device from a computer
connected on the same network node, then the Net Mask may be left at its
default value. Contact your network IT administrator for assistance with
these settings.
3.2 Settings
The user must select the desired device and click the “SETTINGS” button to
obtain access to that device’s configurable parameters.
To change a parameter, click on the field next to the parameter’s name and
enter the appropriate information.
Click the OK button when finished and the information will be uploaded into the
device. There will be a short time delay while the device reboots.