Hall Research VSA-31 - Manual (Page 14)

Model VSA-31
14
. Operating the VSA-31
The volume level indicator will have every other LED turned on when the
VSA-31 is powered off. To operate the VSA-31, first press the power
button. The power button on the VSA-31 will now light up. If you have
uploaded a serial command for the “Power = On” command then that
serial command will now be issued to the projector. Next, select an input
1-3 by pressing the corresponding button. The button you just pressed
will light up and the serial command associated with that button will be
sent to the projector. In addition to issuing serial commands to the
projector the VSA-31 Transmitter will also switch the source of the video
being transmitted to the Receiver to the input you just selected. Only 1
video source will be transmitted to the VSA-31 at any given time. Adjust
the volume by turning the volume knob. You will see the volume level
indicated by the volume LED bar. Volume level is adjusted per input and
saved in memory for each input.
. Resetting the VSA-31
If for any reason you need to reset the VSA-31, press buttons 1 and 3
simultaneously and the unit will reset. This will not result in the loss of
any serial command programming this will only reboot the unit. All the
serial commands are still stored in the unit. You will need to press the
power on button and reselect the input you wish to display.
6.0 Troubleshooting
Make sure that all your connections are solid, and check the state of the
LED’s on the front of the unit. Do not open or try to repair the unit
yourself. There are no customer repairable items in the unit and you will
void your warranty.
Contact HRT Support at 714-641-6607 or via email or web. If you need
to ship your converter for repair, make sure to get a Return Material
Authorization (RMA) number first.