Digi FASTPORT MIL-3200X - Manual (Page 12)

Chapter 2
2-2 MIL-3200X Series of FastPort Print Servers
I
N
S
T
A
L
L
A
T
I
O
N
2.1 Installation Requirements
Before installing FastPort, make sure you have the following:
• MIL-3200X series FastPort
• Power supply
Use a switchable power supply, such as the MIL-16DT
desk-top power adapter included with FastPort. Set for 120
VAC in the continental USA (Default is 220 VAC)
• Appropriate Ethernet cabling, which may include T-
connectors, terminators, external transceivers, or MAUs
• Serial or parallel printers with cabling
2.2 Installing FastPort
To install the MIL-3200X FastPort print server.
1. Record the Ethernet address (located on the bottom of the
unit) for future reference
2. Attach the Ethernet cabling, including:
– MIL-3210X supports 10BASE-T cabling directly; use
category 5 (CAT 5) unshielded twisted pair (UTP)
cabling.
– MIL-3220X supports 10BASE2 cabling directly; use thin
net cabling.
– MIL-3230X supports 10BASE-FL cabling directly; use
multi-mode or single-mode fiber cabling.
Note: Install a micro module for any other type of network connection, refer to
Chapter 3.
3. Refer to Table 2-1 to select an operating mode with the
front panel switches.