Hanna Instruments HI 83225-01 - Manual (Page 36)

36
PHOSPHORUS HIGH RANGE
SPECIFICATIONS
Range 0 to 100 mg/L
Resolution 1 mg/L
Accuracy ±5 mg/L ±4% of reading at 25 °C
Typical EMC Dev. ±1 mg/L
Light Source
Tungsten lamp with narrow band interference filter @ 525 nm
Method Adaptation of the Standard Methods for the Examination of Water and Wastewater,
18 th edition, Amino Acid method. The reaction between phosphorus and reagents
causes a blue tint in the sample.
REQUIRED REAGENTS
Code Description Quantity
HI 93706A-0 Molybdate 10 drops
HI 93706B-0 Amino Acid Powder 1 packet
REAGENT SETS
HI 93706-01 Reagents for 100 tests
HI 93706-03 Reagents for 300 tests
For other accessories see page 57.
MEASUREMENT PROCEDURE
Note: for sample preparation follow the NUTRIENTS SOLUTION (HR) procedure at page 22.
• Select the
Phosphorus HR method using the procedure
described in the Method Selection section (see page 12).
• Fill the cuvette with 10 mL of unreacted sample (up to the
mark) and replace the cap.
• Place the cuvette into the holder and close the lid.
• Press the Zero key. The display will show “-0.0-” when the meter is zeroed and ready for
measurement.
• Remove the cuvette.
• Add 10 drops of HI 937O6A-0 Molybdate reagent.
Phosphorus HR
10 mL