Hanna Instruments HI 255 - Manual (Page 33)

33
Press RANGE. The month will start blinking.
Press the ARROWkeys to change the month.
Press RANGE. The day will start blinking.
Press the ARROW keys to change the day.
Press CFM to save the modified value.
Press CAL to escape without saving.
Beep Status Set
Press CAL when the beep status is displayed. Beep status (On or OFF) will
start blinking.
Press the ARROWkeys to change the beep status (On or OFF).
Press CFM to save the modified beep status.
Press CAL to escape without saving.
Note: • If enabled, an audible signal will follow each key pressed. Inactive
keys have a longer beep. A longer beep can be also heard when the
range limits of a parameter are reached.
• During calibration an audible signal can be heard when the
reading becomes stable.
Baud Rate Set
Press CAL when the baud rate is displayed. The baud rate (600, 1200, 2400,
4800 or 9600) will start blinking.
Press the ARROWkeys to change the baud rate value.
Press CFM to save the modified baud rate value.
Press CAL to escape without saving.
DATE
DATE