Hanna Instruments HI 983310 User Manual

Aquadip, Rugged waterproof tds / °c meter

Advertising
background image

Instruction Manual

AquaDip

Rugged Waterproof

TDS / °C meter

w w w . h a n n a i n s t . c o m

SPECIFICATIONS

Range

0 to 1999 ppm
0.0 to 60.0 °C

Resolution

1 ppm / 0.1°C

Accuracy

±2% f.s. (ppm) / ±0.5°C

Typical EMC

±2% f.s. (ppm) / ±0.5°C

Deviation

TDS Factor

0.5

Calibration

Factory-calibrated

Temperature

Automatic from 0 to 60°C

Compensation

β

=2%/°C, T(ref.)=25°C

Battery Type

2 x 1.5V AAA alkaline

Battery Life

1000 hours of continuous use

Auto-off

After 5 minutes of non-use

Environment

0 to 50°C; 100% RH

Dimensions

94 x 38 x 440 mm (3.7 x 1.5 x 17.3’’)

Weight

200 g (7.8 oz.)

Warranty
All Hanna Instruments meters are warranted for two years against defects in
workmanship and materials when used for their intended purpose and main-
tained according to instructions. This warranty is limited to repair or replacement
free of charge. Damages due to accident, misuse, tampering or lack of pre-
scribed maintenance are not covered. If service is required, contact the dealer
from whom you purchased the instrument. If under warranty, report the model
number, date of purchase, serial number and the nature of the failure. If the
repair is not covered by the warranty, you will be notified of the charges in-
curred. If the instrument is to be returned to Hanna Instruments, first obtain a
Returned Goods Authorization number from the Customer Service department
and then send it with shipping costs prepaid. When shipping any instrument,
make sure it is properly packaged for complete protection.

Recommendations for Users
Before using this product, make sure that it is entirely suitable for the environ-
ment in which it is used. Operation of this instrument in residential areas could
cause interference to radio and TV equipment. Any variation introduced by the
user to the supplied equipment may degrade the instrument EMC performance.
To avoid electrical shocks, do not use this instrument when voltage at the
measurement surface exceeds 24 Vac or 60 Vdc. To avoid damage or burns,
do not perform any measurement in microwave ovens.

ISTAQUADIPR2 05/05

Advertising