I) (ii) – Hase Merida User Manual

Page 36

Advertising
background image

36

room is well-ventilated and open the windows

and outside doors. If needed, use a fan for

faster air circulation.

If the maximum temperature is not reached during the first he-
ating operation, you may notice an odour for a short period of
time the next time the stove is used as well.

7. Lighting the Fire

The firing up phase should be as short as possible, since higher
emissions can occur during this phase.

The slider settings described in Table 1 (see figure on the right)
are recommendations that were determined under confor-
mance testing conditions, in compliance with the relevant stan-
dard. Depending on the weather conditions and the draught ca-
pability of your chimney, accordingly adjust the slider positions
for your Merida to the local conditions.

NOTE!

The Merida may only be operated when the fire

box door is closed; the fire box door may

only be opened to add fuel.

WARNING!

Never use spirits, petrol, or other flammable

fluids to light the stove.

Lighting the Fire

Procedure

Position of Control

Elements

Completely open primary

and secondary air.

Pull primary and secondary air
slider all the way out. (fig. 7)

Open fire grate.

Pull out fire grate slider.

Pile up any remaining ash

and unburned Charcoal

into the centre of the

combustion chamber.

Place 2-3 small logs into

the middle of the fire box;

stack approx. 0.5 kg of dry

wood chips on top.

Light the ignition material

at several places.

Open fire box door.

Close fire box door.

Tab. 1

(I)

(II)

Fig. 7

8. Adding Fuel / Heating at Nominal Thermal Output

More fuel should be added to the fire when the flames from the
previous burning off phase have just gone out.

Adding Fuel / Heating at Nominal Output

Procedure

Position of

Control Elements

Adjust primary and

secondary air.

Close primary air slider

(I), set secondary air slider

(II) to position 3. (fig. 8)

Close fire grate.

Push in fire grate slider.

Add two logs weighing approx.

0,8 kg in total. Place logs with

one end to the front of fire box.

Only add a single layer of fuel.

Open fire box door.

Close fire box door.

Tab. 2

Fig. 8

(I)

(II)

Advertising