Hase Ottawa - Manual (Page 41)

41
When you close the slider (A), the majority of the
warm air fl ows to the heat retaining block and is
gradually dispersed back into the room as cosy
warmth.
A
fi g. 7
7. Initial Operation
NOTE!
During shipment, condensation moisture
can accumulate in the stove’s interior,
which may possibly lead to the appearance
of condensation or water on the stove or
fl uepipes. Please dry off these damp areas
immediately.
The surface of your stove was treated in a sand-
blasting machine before applying the colour coating.
Despite careful and thorough inspection, there may
still be some residual material in the stove body,
which can fall out when your stove is being installed.
NOTE!
To prevent any damage, please immedi-
ately vacuum up these small steel pellets
with a vacuum cleaner.
The fi rst time a stove is operated, the heat develop-
ment causes the emission of volatile components
from the coating, sealing strips and lubricants, and
smoke and odours can occur.
At a higher combustion temperature, this one-time
process can take between 4 to 5 hours.
To achieve this higher combustion temperature,
please increase the fuel quantity recommended in
Section 9, „Adding Fuel/ Heating with Nominal Ther-
mal Output“, by approximately 25%.
CAUTION!
To prevent adverse effects on health, no-
body should stay in the room(s) during
this process unless absolutely necessary.
Make sure the room is well-ventilated and
open the windows and outside doors. If
needed, use a fan for faster air circulation.
If the maximum temperature is not reached during
the fi rst heating operation, you may notice an odour
for a short period of time the next time the stove is
used as well.