HITEC Flash 7 - Manual (Page 64)

7 Channel 2.4 GHz Aircraft Computer Radio System
7 Channel 2.4 GHz Aircraft Computer Radio System
Section 5: Acro and Glider Programming Menu
63
Ailevator Mixing cont.
13. Press the back button to return to the Ailevator Mix menu.
14. Repeat steps 2-13 using the lower “ELEV” and “ELE2” fields to set servo endpoints when pitch (elevator)
commands are given.
11. Scroll to highlight the “R/D” (right/down) field and press the
jog dial to activate the menu.
12. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired servo endpoint when a right
roll command is given. Press the jog dial to confirm your input.
Many models (especially large-scale aircraft) fly through turns more smoothly when aileron and rudder
commands are used simultaneously. The Aileron-Rudder mix will automatically apply rudder input when
aileron commands are given.
To configure an aileron-rudder mix:
15. If elevator and/or aileron functions operate in the incorrect
direction, highlight the direction field (“nor”) under the
reversed function and press the jog dial to activate the
menu.
16. Push the back button twice to return to the model function
menu.
1. From the model menu, rotate the jog dial to highlight
“AILE>RUDD” and press the jog dial once to enter the
activation menu.
2. Press the jog dial again to activate the menu.
3. Rotate the jog dial to select “ACT” (activate), then press the jog
dial to confirm your selection and activate the aileron-rudder
mix menu.
Aileron to Rudder Mixing
4. Scroll to highlight the “RATE” field. Press the jog dial to activate
the menu.
5. Scroll to highlight the “L/U” (left/up) field and press the jog
dial to activate the menu.
6. Rotate the jog dial to increase (clockwise) or decrease
(counter-clockwise) the desired rudder travel when a left roll
command is given. Press the jog dial to confirm your input.