HITEC Focus 6 FM - Manual (Page 6)

5
The trim lever on each control stick is used to correct (trim out) flight
characteristics. After the initial test flight note the positions of the control surfaces that
required trim. Next center trim levers, turn off the receiver radio. Now adjust the control
clevises of the surfaces that required trim so that the surfaces are in the same position
before the trim levers were re-centered. Turn on the receiver radio and recheck the control
surface to ensure that all the corrections were applied in the correct direction.
5. Operation & adjustment
A. Control stick length & tension & trim lever adjustments
The unique open-stick assembly
provides fully adjustable stick tension
“feel”. Turning the tension adjustment
screw counter clockwise will soften
(decrease the tension) the feel of the
Control stick (fig 4)
CP- variable resistors improve the
neutral characteristics and resolution of
the servo positioning.
All of the molded parts are
fabricated from high-grade
polycarbonate that is unaffected by
temperature and humidity.
Turn with a Phillips
screwdriver
The spring becomes
stronger when the
screw is turned
counterclockwise
The length of the nonslip control sticks can be adjusted to suit the require-
ments of the operator. (fig 5)
fig 4
• Set to the desired length by
turning the knob, then lock.
Adjusting knob
• Unlock
fig 5
Remove the transmitter rear
cover and open the P.C. Board