HITEC HTS-Navi - Manual

HTS-NAVI
Instruction Manual
I. Introduction
Thank you for purchasing Hitec’s HTS-NAVI (Navigator), wireless USB telemetry receiver.
Our new HTS-NAVI takes our telemetry system to the next level of convenience and functionality.
This USB telemetry receiver lets you wirelessly download and display essential telemetry
information on your PC. No more cables getting in the way!
Compatible with any radio fitted with Hitec AFHSS 2.4GHz system, the HTS-NAVI will display
all telemetry information transmitted from your plane equipped with Hitec telemetry sensors.
Installation
1. Download & install HPP-22 software. The HPP-22 is a software center for all Hitec telemetry
products. Visit www.hitecrcd.com and go to support > download > software > HPP-22 to
download HPP-22 PC Program.
2. Double click HPP-22 icon to install the program.
Link Process
HTS-NAVI is required to link with your 2.4GHz system
(Spectra 2.4, Spectra 2.4J module or Hitec 2.4GHz built-in module radios) before use.
Please follow the link process as shown below.
3.Click HTS-CC(Hitec Telemetry System Command Center) icon when the HPP-22 program
window pops up.
- Wireless USB AFHSS 2.4GHz Receiver for Hitec Telemetry system
- Telemetry display & telemetry data save on PC
- Smart link
- Auto version check
- Dimension (L x W x H) :76 x 22.3 x 14 mm (without antenna)
- Frequency: Adaptive Frequency Hopping Spread Spectrum 2.4GHz band
*Hitec’s Telemetry System has been designed for R/C hobby purpose, so please note that Hitec is not liable for any
damages or injuries caused by improper usage for other purposes.
Ⅲ .How to Use?
CLICK
2. Connect HTS-NAVI to USB Port on your PC.
76
22.3
14
2
Ⅲ .How to Use?
This USB type 2.4GHz receiver – HTS-NAVI is made easy to use.
- Installation:
1. Download & install HPP-22 software. The HPP-22 is a software center for all Hitec telemetry
products. Visit www.hitecrcd.com and go to support > download > software > HPP-22 to
download HPP-22 PC Program.
2. Double click HPP-22 icon to install the program.
- Link Process:
HTS-NAVI is required to link with your 2.4GHz system
(Spectra 2.4, Spectra 2.4J, and Hitec 2.4GHz built-in module radios) before use.
Please follow the link process as shown below.
1. Run “HPP-22 PC Program” by double click HPP-22 icon shown below.
2. Connect HTS-NAVI to USB Port on your PC.
3.Click HTS-CC(Hitec Telemetry System Command Center) icon when the HPP-22 program
window pops up.
CLICK CLICK
CLICK
1. Run “HPP-22 PC Program” by double click HPP-22 icon shown below.
CLICK
I. Introduction II .Specification Features
Warning