Hope Tech Mono M4 Brake - Manual

HYDRAULIC DISC BRAKE SYSTEM
This MonoM4 brake system is destinated to be used on XC, All Mountain and
Enduro bikes where consistant brake performance is important without compro-
mising on the weight.
The Mini lever will give a smooth and progressive feel, it features a split clamp
for easy fitting, integrated reservoir for bleeding and adjustable lever reach.
The one piece, four differentiated piston MonoM4 caliper is machined from a
solid billet of aluminium which is designed to offer both power and stiffness.
Depending on forks, frame and rotor size, an adaptor bracket may be required.
The rotor is available with two different options, the standard stainless steel
disc or the floating one with aluminium centre.
· Don’t overestimate your technical capabilities. This brake system must
be fitted by a competent cycle mechanic using the correct tools. Incorrect
installation could result in brake failure that could cause serious or fatal
injuries.
· Your brake system will generate heat during braking. Never touch either
the disc or caliper after a long braking period as this could cause severe
burns.
· Before each ride always check the brake for proper function, the brake
pads for wear and that there is no system damage resulting in fluid leaks.
· It’s common practice to also check that your wheel quick release skewers
are securely installed and tightened.
· Your braking performance will improve in almost all conditions, please
take time to become familiar with your new brake. Always ride within your
own abilities.
· Brake pads contaminated with brake fluid, chain lubricant or unsuitable
bike cleaner will need replacing because the overall brake performance will
be greatly diminished.
· Please refer to the complete manual for more information including
servicing and maintenance.
· If you have any doubts or questions please contact your dealer or the
appropriate distributor for your country.
DESCRIPTION
WARNING
BOX CONTENTS
Before first use please check the contents of the box are described as below.
Once again, don’t overestimate your technical skills. If you are not familiar with
this sort of installation we advise that this brake system should be fitted by a
competent cycle mechanic.
. Torx T25 driver
. 5mm Allen key
. 4mm Allen key
. 2mm Allen key
. Flat blade screw driver
1
2
3
4
5
6
1: Brake system, fully bled
2: 2x M6x18 caliper bolts
3: Rotor ( φ183mm shown)
4: 6x Torx T25 disc bolts
5: Adaptor bracket (if
required)
6: 2x M6x18 adaptor
bracket bolts (if required)
TOOLS REQUIRED
QUICK INSTALLATION
GUIDE
MonoM4
www.hopetech.com www.hopetech.com