Hope Tech Moto V2 Brake - Manual

HYDRAULIC DISC BRAKE SYSTEM
This Moto V2 brake system will provide awesome braking power yet be very
progressive, the system has been designed to cope with the heat generated in
extreme riding conditions such as downhill and free ride.
The Moto lever gives a smooth, solid and progressive feel. It features the Bite
Point Control (BPC) to adjust lever feel, lever reach adjustment is also possible.
The one piece Moto V2 caliper machined from a solid billet of aluminium
which is designed to offer both power and stiffness. Depending on forks, frame
and rotor size, an adaptor bracket may be required.
The fitted braided hose will help prevent any damage that could occur in
extreme riding conditions.
The rotor is available with two different options, the standard floating disc or
the ventilated one.
· Don’t overestimate your technical capacities. This brake system must be
fitted by a competent cycle mechanic using the correct tools. Incorrect
installation could result in brake failure that could cause serious or fatal
injuries.
· Your brake system will generate heat during braking. Never touch either
the disc or caliper after a long braking period as this could cause severe
burns.
· Before each ride always check the brake for proper function, the brake
pads for wear and that there is no system damage resulting in fluid leaks.
· It’s common practice to also check that your wheel quick release skewers
are securely installed and tightened.
· Your braking performance will improve in almost all conditions, please
take time to become familiar with your new brake. Always ride within your
own abilities.
· Brake pads contaminated with brake fluid, chain lubricant or unsuitable
bike cleaner will need replacing because the overall brake performance will
be greatly diminished.
· Please refer to the complete manual for more information including
servicing and maintenance.
· If you have any doubts or questions please contact your dealer or the
appropriate distributor for your country.
DESCRIPTION
WARNING
BOX CONTENTS
Before first use please check the contents of the box are described as below.
Once again, don’t overestimate your technical skills. If you are not familiar with
this sort of installation we advise that this brake system should be fitted by a
competent cycle mechanic.
. Torx T25 driver
. 5mm Allen key
. 4mm Allen key
. 2mm Allen key
. Flat blade screw driver
1
2 3
4
5
6
1: Brake system, fully bled
2: 2x M6x18 caliper bolts
3: Rotor ( φ203mm shown)
4: 6x Torx T25 disc bolts
5: Adaptor bracket (if
required)
6: 2x M6x18 adaptor
bracket bolts (if required)
TOOLS REQUIRED
QUICK INSTALLATION
GUIDE
www.hopetech.com www.hopetech.com