Kipp&Zonen CVF4 Ventilation Unit - Manual (Page 9)

Instruction Manual - CVF4
9
This manual will show you how to install, use and maintain the CVF4 Ventilation Unit. The CVF4 is meant for ventilating solar
radiation sensors with the purpose to keep the mounted radiometer window or dome clean from dew, precipitation and
pollution. It can be used outdoors under all-weather conditions. The CVF4 has a built in heater to keep the air just above
ambient temperature.
Both the World Meteorological Organisation (WMO) and the Baseline Surface Radiation Network (BSRN) guidelines advise using
a ventilator to optimise the performance of radiometers in general.
The use of the CVF4 will:
- Increases the maintenance interval.
- Increase the accuracy of the measured data (cleaner dome / window)
- Reduce the zero offset of the radiometer.
The CVF4 is meant for all CM, CMP, SMP, CG, CGR and CUV radiometers. However with the CMP 3 and SMP3 and CGR 3 the
ventilation effect will be less due to the larger opening around the dome. The CVF4 is meant to run continuously. The heater can
either be switched on permanently for cold regions or be switched by a data logger or clock to remove dew in the morning and
be switched off afterwards. In that case the heater is operated from a 2 hours before sunrise to an hour after sunrise. This saves
power in situations where power is limited such as PV operated sites.
This manual, together with the instruction sheet, give information related to installation, maintenance, product specifications
and trouble shooting of the CVF4.
If any questions should remain, please feel free to contact your Kipp & Zonen dealer or e-mail: [email protected] .
For information about other Kipp & Zonen products or to check for any update of this manual, go to www.kippzonen.com .
1. Introduction
1.1 CVF4 top side
Ventilator
Heater
Mounting holes CMP 3, SMP3 and CGR 3
Mounting holes all other instruments
Connector
Cover nut
Slit for radiometer cable
1.2 CVF4 bottom side
Filter cover
Connector box
Mounting feet for SOLYS 2 / Feet for stabilisation
Feet for stabilisation / Mounting feet for 2AP
Mounting holes for mounting feet on CM 121C shadow ring adapter
Cover nut