Konig Electronic Tone generator with amplifier probe - Manual (Page 4)

4
• Coax testing:
1. To test unterminated coax, connect the red lead to the outer shield and the black lead to the
centre conductor or the red lead to the outer shield and the black lead to the ground.
2. To test the terminated coax, connect the red lead to the connector housing and the black lead to
the centre pin or the red lead to the connector housing and the black lead to the ground.
• Battery replacement:
1. The amplifier probe is maintenance free except for the battery replacement.
Remove the screw from the battery compartment, replace the 9 V battery and screw the lid
back on.
Safety precautions:
Do not expose the product to water or moisture.
DO NOT CONNECT TO AN ACTIVE AC CIRCUIT EXCEEDING 24 V IN THIS MODE.
Maintenance:
Clean the product only with a dry cloth.
Do not use cleaning solvents or abrasives.
Warranty:
Any changes and/or modifications to the product will void the warranty. We cannot accept any liability
for damage caused by incorrect use of this product.
Disclaimer:
Designs and specifications are subject to change without prior notice. All logos, brands and product
names are trademarks or registered trademarks of their respective holders and are hereby recognised
as such.
Disposal:
• This product is designated for separate collection at an appropriate collection point. Do not
dispose of this product with household waste.
• For more information, contact the retailer or the local authority responsible for waste
management.