Konig Electronic VGA over UTP receiver - Manual (Page 2)

2
ENGLISH
VGA UTP receiver with audio
Introduction
This VGA UTP receiver with audio is an ideal device for local displaying and remote viewing. It
receives the VGA signal and audio signal from one of the two identical outputs from splitter (CMP-
REPEATVGA3). Each receiver by Cat5x 1 works with the sender as a full functional module by
receiving the distributed signal from the sender and transmitting to displays individually. Only by the
most inexpensive UTP cable with cross stand inside, the full functional module extends the VGA
display up to a maximum of 300 metres.
Features
This device has many features that enable it to perform in a superior manner. Among those features
you will find:
• Extends VGA video and stereo audio signal to a maximum of 300 meters over one UTP cable with
cross stand inside
• Adjust GAIN and PEAK to adapt for the different length of UTP cable
GAIN: Brightness adjustment
PEAK: Skew adjustment
• Supports a maximum resolution of 1920x1200
• Output at unit: 1x VGA output and audio connection for speaker set
Specifications
Input /Output connector
Input connector
RJ45
Output connector VGA (Female 15pin), stereo audio
Operating frequency
Vertical frequency range
60/75/85Hz
Resolutions (pc)
640X480
800X600
1024X768
1280X720
1280X768
1280X960
1280X1024
1600X900
1600X1200
1920X1080
1920X1200
Mechanical
Size of receiver (L-W-H)
81.5Ч43Ч23 mm
Weight of receiver (Net) 108 g