Konig Electronic AM/FM clock radio with red LED - Manual (Page 2)

2
ENGLISH
LOCATION OF CONTROLS
1. On/Off/Auto
2. Time set
3. Alarm set/Off
4. Sleep
5. Snooze button
6. Hour
7. Minute
8. Volume control / Buzzer
9. Band switch
10. Tuning control
11. AUTO indicator
12. HI-LO dimmer
BOTTOM: Battery compartment for 9-Volt (6F22) battery (not included) for back up power.
CLOCK OPERATION
1. Plug the mains cord into a 230V AC wall outlet
2. The unit is now working; the time flashes in the display.
3. To set the correct time, simultaneously press the TIME SET Button (2) and HOUR button (6) and release
when the correct hours are displayed. Now simultaneously press the MINUTE button (7) and the TIME
SET button (2) to set the correct time.
RADIO OPERATION
1. Slide the ON/OFF/AUTO switch (1) to the ON position.
2. Slide the BAND switch (9) to FM or AM.
3. Turn the volume control (8) to the desired volume.
4. Turn the TUNING control (10) to select your favourite station.
5. Antenna
For AM reception, this radio incorporates a highly sensitive ferrite antenna.
For FM reception, this set is equipped with an external FM wire antenna. Unwind to full length for peak
performance.
WAKE UP TO RADIO
After selecting your station and setting the volume to the desired level, proceed as follows:
1. Slide the ON/OFF/AUTO switch (1) to the AUTO position.
2. Press and hold the ALARM SET button (3) and press the HOUR button (6) and then the MINUTE
button (7) until the correct alarm time is set. To check the alarm time, simply press the ALARM SET
button (3) . The preset alarm time will continue to be registered in the time memory and the radio will
switch on the next day at the same time. To turn the radio off, simply press the ALARM OFF button (3).
3. When the alarm is set, but you want to listen the radio before the set alarm time, press the SLEEP
button (4) once to turn the radio on and press the SNOOZE button (5) again to turn the radio off.
WAKE UP TO BUZZER
Set the controls as for “Wake up to Radio” but with volume control (8) to the BUZZER position. The buzzer can
be switched off by pressing the ALARM OFF button (3) or change to radio by sliding the ON/OFF/AUTO switch
(1) to the ON position.
SLEEP TO RADIO
The radio can be set to play and to switch off automatically after 1 minute up to 1 hour and 59 minutes: With
all controls preset in the “Wake up to Radio” position press the SLEEP button (4) and the MINUTE button (7)
to count down to the desired sleep time. To switch off the radio before the end of the registered sleep time,
simply press the SNOOZE button (5).