Konig Electronic Wireless microphone system - Manual (Page 4)

4
ENGLISH
Operation
1. Put the antenna straight up for optimal reception.
2. Connect the connection cable with the 6.35 mm plugs to the output of the receiver and
mixer or amplifier.
3. Connect the DC plug of the AC/DC adapter to the DC input on the rear side of the
receiver. Connect the power plug to a wall outlet.
Note: the receiver is automatically powered on.
4. Open the battery compartment of the microphone and place 2x AA batteries according
to the indicated polarity markers.
5. Switch on, after closing the battery compartment, the microphone with the ON/OFF
switch.
6. The system is ready to use.
Specifications
Frequency:
UHF 863 MHz
Transmit power: 10 mW
Dynamic range: >90 dB
Total harmonic distortion: <0.5%
Frequency response: 40 Hz–15 KHz, ±3 dB
Modulation: FM
Audio output level: 0–400 mV
Power supply: 230~240 V AC, 17 V DC
Power consumption: 4 W
S/N ratio: >90 dB
Battery: 2x AA 1.5 V
Battery life: 4–6 hours