Konig Electronic Slim-Line induction cooker touch control 2000W - Manual (Page 4)

44
English
Use
Setting the power
• Press the function button until the power indicator
comes on. The display shows “1600”.
• Turn the setting dial clockwise to increase the power.
• Turn the setting dial counterclockwise to decrease the
power.
Setting the temperature
• Press the function button until the temperature
indicator comes on. The display shows “200°”.
• Turn the setting dial clockwise to increase the
temperature.
• Turn the setting dial counterclockwise to decrease the
temperature.
Setting the timer
• Press the function button until the timer indicator
comes on. The display shows “00:00”.
• Turn the setting dial clockwise to set the hours.
• Turn the setting dial counterclockwise to set the
minutes (1-minute steps).
• Press the function button to confirm or wait until the
display stops flashing.
• At the end of the countdown, a beep will sound and
the device will go to standby mode.
To cancel the function:
• Press the on/off button to go to standby mode. The
timer indicator goes off.
• Press and hold the function button to resume
operation with the set power or temperature settings.
The timer indicator goes off.
Hints for use
• Insert the mains plug into the wall socket. A beep will
sound and the indicators flash once. The on/off
indicator starts to flash. The device is in standby mode.
• Place the cookware in the centre of the cooking zone.
• Press the on/off button to switch on the device. The
on/off indicator lights continuously. The display shows
“----”.
• Set the device according to your cooking requirements.
• After use, press the on/off button to set the device to
standby mode. The on/off indicator starts to flash.
• Remove the mains plug from the wall socket.
• Allow the device to cool down completely.
Error codes
Description Solution
E0 Internal circuit error. (1) Use suitable cookware.
(2) Switch off the device, allow
the device to cool down
completely and switch the
device on again.
E1
No cookware or unsuitable
cookware used.
E7 Top plate overheating.
E2 Internal overheating.
Contact the service centre.
E3 Overvoltage.
E4 Undervoltage.
E5
Open-circuit error or
short-circuit error
(top plate sensor).
E6
Open-circuit error or
short-circuit error
(IGBT sensor).
Cleaning and maintenance
Warning!
• Before cleaning or maintenance, switch off the device,
remove the mains plug from the wall socket and wait
until the device has cooled down.
• Do not use cleaning solvents or abrasives.
• Do not immerse the device in water or other liquids.
• Do not attempt to repair the device. If the device does
not operate correctly, replace it with a new device.
• Clean the outside of the device using a soft, damp
cloth. If necessary, use a little neutral detergent.
Thoroughly dry the outside of the device with a clean,
dry cloth.
• Clean the ventilation openings using a soft brush.
Technical data
Power settings
300 W / 600 W / 900 W / 1200 W /
1400 W / 1600 W / 1800 W / 2000 W
Temperature settings
60 °C / 80 °C / 100 °C / 120 °C
140 °C / 160 °C / 180 °C / 200 °C
Timer settings 1 minute ~ 11 hours / 59 minutes