Konig Electronic Camera ring light 60 LED - Manual (Page 3)

3
ENGLISH
Ring Light
1. Insert 4 AA batteries into the power pack. Batteries are not included. Use Alkaline or NiMH
rechargeable batteries. Be sure batteries are installed according to the diagram shown inside the
battery compartment.
2. Mount the power pack onto the accessory show of the camera.
3. Select the correct mounting ring and slide into the grooves on the back of the ring light until it snaps
into position.
4. Screw the ring light assembly onto the filter threads of your lens. Adjust to horizontal.
5. Install the power cord from the power pack to the ring light.
6. Use the dimmer control on the power pack to adjust the light intensity.
To remove from the lens, first remove the power cord and then unscrew the ring light.
Specifications:
60 Daylight Balanced LED lights.
Designed for close up photography up to 4 ft.
Vignetting may occur if using your lens on the wide angle setting.
Also may be used as a fill-in light.
Dimmable control.
Uses 4 AA batteries, Alkaline or NiMH rechargeable (not included).
Safety precautions:
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
General:
- Designs and specifications are subject to change without notice.
- All logos brands and product names are trademarks or registered trademarks of their respective
holders and are hereby recognized as such.
- This manual was produced with care. However, no rights can be derived. König Electronic can not
accept liability for any errors in this manual or their consequences.
- Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products
should not be mixed with general household waste. There is a separate collections system for
these products.