Konig Electronic Dummy outdoor camera - Manual (Page 3)

3
3. Open the battery compartment with a
screwdriver (4 screws).
4. Place 2x AA 1.5 V batteries into the
battery compartment matching the
polarity markings (+ and -), to activate
the flashing LED.
Replace the battery compartment and
back cover after inserting the batteries.
Maintenance:
Clean the housing with a dry or damp cloth.
Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage
caused due to incorrect use of this product.
Disclaimer:
Designs and specifications are subject to change without notice. All logos, brands and product names
are trademarks or registered trademarks of their respective holders and are hereby recognized as
such.
Disposal:
• This product is designated for separate collection at an appropriate collection point. Do not
dispose of this product with household waste.
• For more information, contact the retailer or the local authority responsible for waste
management.
This product has been manufactured and supplied in compliance with all relevant regulations and
directives, valid for all member states of the European Union. It also complies with all applicable
specifications and regulations in the country of sales.
Formal documentation is available upon request. This includes, but is not limited to: Declaration of
Conformity (and product identity), Material Safety Data Sheet and product test report.