Krix Volcanix - Manual (Page 11)

Due to continued development specifications may change without notice.
Volcanix: specifications
Drivers
Bass Driver
Electronics
Amplifier Power
Amplifier S/N
Distortion
- Input to Speaker
Line Level Inputs
General
Frequency Range
Output
Auto Power On / Off
Phase Select
Filters
Cabinet
Enclosure Type
Dimensions
Material
Finish
Weight
Nominal 305mm (12”) diameter paper cone driver, 50mm long throw
voice coil, developed for high level, low frequency reinforcement
450 watts RMS into the nominal 4 ohm driver
>90dB
<0.1% - @ 400 watts RMS
Left Input (mono)
300mV RMS for maximum output
Left + Right Input (stereo) 150mV RMS for maximum output
16Hz - 200Hz (-6dB) in room response
125dB maximum SPL in room response
15 minute delay before switching to standby after no input signal
0° or 180° (relative to input signal)
Low pass filter 50-195Hz, Bypass
High pass filter to limit driver excursion below 22Hz
Bass reflex, front vented
506mm high x 400mm wide x 470mm deep (including grille and feet)
18mm MDF
Vinyl or lacquered timber veneer
23kg
specification
warranty
5 year warranty applies to the cabinet and
speaker.
2 year warranty applies to the amplifier and
related internal electronics.
(Refer to the details on the warranty card
supplied)
queries
If you have any queries regarding the Tektonix
or Volcanix setup procedure or any other Krix
product, please contact your nearest Krix
retailer or Krix directly. Contact details are on
the back cover of this booklet.
Tektonix: specifications
Drivers
Bass Driver
Electronics
Amplifier Power
Amplifier S/N
Distortion
- Input to Speaker
Line Level Inputs
General
Frequency Range
Output
Auto Power On / Off
Phase Select
Filters
Cabinet
Enclosure Type
Dimensions
Material
Finish
Weight
Nominal 275mm (11”) diameter paper cone driver, 50mm long throw
voice coil, developed for high level, low frequency reinforcement
450 watts RMS into the nominal 4 ohm driver
>90dB
<0.1% - @ 400 watts RMS
Left Input (mono)
300mV RMS for maximum output
Left + Right Input (stereo) 150mV RMS for maximum output
22Hz - 200Hz (-6dB) in room response
123dB maximum SPL in room response
15 minute delay before switching to standby after no input signal
0° or 180° (relative to input signal)
Low pass filter 50-195Hz, Bypass
High pass filter to limit driver excursion below 26Hz
Bass reflex, front vented
451mm high x 360mm wide x 415mm deep (including grille and feet)
18mm MDF
Vinyl or lacquered timber veneer
18kg
11