LA Audio CAN-D - Manual (Page 4)

 www.laaudio.co.uk 
Controls.
1. Delay Units
Selects the scale used to display the delay setting. Pressing the
button cycles through feet, meters and milliseconds. The current
format is indicated by its corresponding LED.
2. Headphone Outputs
.mm and .mm jack outputs are available. These are
paralleled from a single output, so the connection of two pairs of
headphones will result in reduced level.
3. Delay Adjust
Adjust delay in increments based on the Delay Units setting.
4. Delay In/Out
Bypasses delay. When the delay is out, the screen will flash “OUT”
and show the delay time alternately.
MOISTURE
DO NOT expose the unit to rain or moisture. If your CAN‑D
should become so exposed REMOVE the mains power
immediately.
HEAT
ALWAYS site your CAN‑D away from sources of heat including
direct sunlight and ensure adequate ventilation around the unit.
Regulatory Compliance
This product complies with both the EMC Directive (89//
EEC) and the Low Voltage Directive (//EEC) as issued by
the Commission of the European Community. Compliance with
these directives imply conformity with the following European
standards:
EN00 Product safety
EN10‑1 Electromagnetic Interference (Emission)
EN10‑ Electromagnetic Susceptibility (Immunity)
PROTECT YOUR EARS
Exposure to high sound pressure levels can
cause irreparable hearing damage. The
higher the level, the shorter the period of
exposure required to cause damage. Time
aligned headphones should allow you to turn
down your headphones by around dB and
receive better intelligibility. Practice safe sound
by turning down and, where possible, reducing
your exposure to high sound levels.