Lab.gruppen fP2600 - Manual (Page 4)

10. Do not use this amplifier if the power cord is broken or frayed. Protect the power cord from
11. cessories specified by the manufacturer.
ounting instructions. When a rack on
13.
. Do
15. t.
en the apparatus has
maged
or moisture
re is damaged
17. ver will expose hazardous voltages.
18. ent, especially if
PKR= rëÉê=кЙлйзелбДбдбну=
being walked upon or pinched particularly at the plugs and the point where it exits from the
apparatus.
Only use ac
12. The unit is intended to use in a 19” rack. Follow the m !
wheels is used, use caution when moving the loaded rack to avoid injury from tipping over.
Unplug this apparatus during lightning storms or when unused for long periods of time.
14. Do not connect an amplifier output in parallel or series with any other amplifier’s output
not connect the amplifier output to any other voltage source, such as battery, mains source, or
power supply, regardless of whether the amplifier is turned on or off.
Do not run the output of any amplifier back into another channel's inpu
16. Refer all servicing to qualified service personnel. Servicing is required wh
been damaged in any way such as:
• Power-supply cord or plug is da
• Liquid has been spilled into the unit
• An object has fallen into the unit
• The unit has been exposed to rain
• The unit does not operate normally
• The unit was dropped or the enclosu
Do not remove top or bottom covers. Removal of the co
There are no serviceable parts inside and removal may void the warranty.
An experienced user shall always supervise this professional audio equipm
inexperienced adults or minors are using the equipment.
!
contin
PKRKN= pйЙ~вЙк=З~г~ЦЙ=
y powerful and can be potentially dangerous to both, loudspeakers and
kers’
uo
tors can be used to reduce the gain, it is still possible to reach
PKRKO= pйЙ~вЙк=змнймн=Ь~т~кЗ=
dous output voltages. To avoid electrical shock,
Your amplifier is ver
humans alike. Many loudspeakers can be easily damaged or destroyed by overpowering,
especially with the high power available from a bridged amplifier. Always check the spea
us and peak power capabilities.
Even if the amplifier’s front panel attenua
full output power if the input signal level is high enough.
Power amplifiers are capable of producing hazar
do not touch any exposed speaker wiring while the amplifier is operating. See page
13 abou
outputs for proper connection of speakers.
t
PKRKP= o~Збз=бенЙкСЙкЙеЕЙ=
and found to comply with the limits for a Class B digital device,
gainst
r in a
ause harmful interference to radio or television reception, which can be
ference
.
e equipment and receiver.
m that to which the receiver is
• dealer or an experienced radio/TV technician for help.
This equipment has been tested
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection a
harmful interference from electrical equipment. This product uses radio frequency energy and if not
used or installed in accordance with these operating instructions, may cause interference to other
equipment, such as radio receivers. However, there is no guarantee that interference will not occu
particular installation.
If this equipment does c
determined by turning the equipment on and off, the user is encouraged to try to correct the inter
by one or more of the following measures:
• Reorient or relocate the antenna
• Increase the separation between th
• Connect the equipment into an outlet on a circuit different fro
connected.
Consult the
i~ÄKÖêìééÉå== = = = = ====================== ======================== P
rëÉê=j~ем~д===Сm=OSMMLNNR======sÉêëáçå=MKV========OMMPJMOJOP=