Labconco FreeZone Stoppering Tray Dryers 79480 Series - Manual (Page 14)

Chapter 3: Getting Started
Product Service 1-800-522-7658 10
Installing the Tray Dryer on the Freeze Dry System
The following tools are required to install the Stoppering Tray Dryer onto a
FreeZone Freeze Dry System base unit: Flat blade screwdriver or 5/16" socket
and a 7/16" wrench or socket.
Remove the four plastic hole plugs from the top of the Freeze Dry System on
which the Stoppering Tray Dryer is to be mounted. If the Freeze Dry System has
a flat gasket around the 3.0 inch vacuum port, remove it. Loosen both clamps on
the lower connection hose and slide the hose upward so the bottom edge of the
hose is above the lower edge of the stainless steel tube. Snug both clamps on the
hose to hold them in place.
Lift the Stoppering Tray Dryer into place on your Freeze Dry System while
centering the vacuum coupling over the vacuum connection port. Align the four
mounting holes in the Stoppering Tray Dryer support stand with the four holes in
the top of the Freeze Dry System.
NOTE: Do not lift the Stoppering Tray Dryer by the door or disturb
it.
Install the four bolts, nuts, and washers provided. Loosen the clamps and slide
the lower hose down over the vacuum connection port. Orient the clamps to gain
access and tighten the clamps to provide a leak-free connection.