Legacy Audio Metro - Manual (Page 11)

11
11
Speaker Connections
Once you’ve found a place in your room, the next step is connecting the
Metro to your existing system. Listed below you will find 3 options.
Option 1: Connecting the Metro using the stereo Low Level preamp/processor
inputs.
NOTE: if using the low-level inputs, we suggest using cables that are no
longer than 5 meters. Longer lengths of RCA cable can result in greater
noise and attenuation of the signal.
If using Left/Right output jacks from the preamp, the internal circuit module of the
Metro will sum the two channels together. When using the left and right low level
inputs on the subwoofer, the internal crossover of the subwoofer is being used. The
crossover frequency and level will be controlled by the appropriately labeled
controls on the rear panel of the sub.
The Left/Right line output jacks can be used to send a crossed over high frequency
signal.