LEHR 5.0 HP 4-STROKE - Manual (Page 14)

TILTING UP AND DOWN
If the engine will be stopped for some time and the boat is moored in shallows, the outboard motor should
be tilted up to protect the propeller and casing from damage from collision with obstructions, and also to
reduce salt corrosion.
WARNING: Be sure all people are clear of the outboard motor when tilting up and down, also be careful not
to pinch any body parts between the drive unit and engine bracket.
WARNING: Before tilting the outboard motor, follow the procedure under “Stopping Engine” in this section.
Never tilt the outboard motor while the engine is running. Sever damage from overheating can
result. Do not tilt the engine by pushing the tiller handle because this could break the handle.
Keep the power unit higher than the propeller at all times otherwise water could run into the
cylinder and cause damage. The outboard motor cannot be tilted while in reverse.
LEHR | ALL RIGHTS RESERVED 2012-2013 12
OPERATION
PROCEDURE FOR TILTING UP
1. Place the gear shifter lever in neutral and face the outboard motor forward.
2. Tighten the steering friction adjuster by turning it clockwise to prevent the motor from turning freely.
3. Hold the carrying handle and tilt the engine up fully until the tilt support lever automatically locks.
PROCEDURE FOR TILTING DOWN
1. Slightly tilt the outboard motor up.
2. Slowly tilt the outboard motor down while pulling the tilt support lever up.
3. Loosen the steering friction adjuster by turning it counterclockwise, and adjust the steering friction
according to operator preference.
TILT SUPPORT
LEVER
STEERING FRICTION
ADJUSTER
BOW DOWN
Too much trim-in causes the boat to “plow” through the water, decreasing fuel economy and making it hard
to increase speed. Operating with excessive trim-in at higher speeds also makes the boat unstable.
Resistance at the bow is greatly increased, heightening the danger of “bow steering” and making operation
difficult and dangerous.
NOTE: Depending on the type of boat, the outboard motor trim angle may have little effect on the trim of the
boat when operating.