LEHR Eco Trimmer - Manual (Page 17)

LEHR | ALL RIghTS ReSeRved 2008-2009 17
BrUSH CUTTer BlaDe remoVal / inSTallaTion
1.Remove the cotter pin (Fig. 38).
Fig. 38
Left-Hand Thread Nut
Cotter Pin
Loosen
2. Insert an allen key into the hole in the shroud to
lock the shaft. Remove the left-hand thread nut to
dissasemble with tool provided in the tool kit (Fig. 39).
Fig.39
Hole
Brush Cutter Blade
Fig.40
Left-Hand Thread Nut
Clamp Plate
Star Washer
• For reassembly, install all components in the correct
sequence ( Fig. 40).
• Tighten the left-hand thread nut until snug and install
a new cotter pin.
GUarD CHanGe
NOTE: When using the brush cutter blade remove
the bottom shield attachment by removing the screw.
Replace when using line trimmer head (Fig. 41).
Fig. 41
Bottom Shield
Attachment
Screw
Cutting Attachment
Sheild
roCKer arm ClearanCe aDJUSTmenT
This requires partial disassembly of the engine. If you
feel unsure or unqualified to perform this, take the unit
to an authorized service center.
1. Remove the four screws on the engine cover with a
phillips head screw driver (Fig. 42).
2. Remove the engine cover.
3. Disconnect the spark plug wire.
4. Clean dirt from around the spark plug. Remove the
spark plug by using tool provided, turn CCW.
NOTE: Inspect the valve to rocker arm clearance with
a feeler gage after the first 25 hours of operation. The
engine must be cold when checking or adjusting the
valve clearances. This task should be performed in a
clean dust free environment.
Fig.42
Engine cover
screws
Engine cover
screws
6. Snap the free length of lines into top grooves in reel and pull
through holes on trimmer head body (Fig. 34 and Fig. 35).
3. Remove in the sequence shown (Fig. 40).
MAINTENANCE
`