LG Motorsports LG C6 Z06 Pro Long Tube Headers - Manual (Page 3)

While still on the passenger side of the car there is a wiring harness that is above the
starter that is clipped into the frame. This will need to be unclipped and re-routed clear of
the header and zip tied out of the way so the header does not burn these wires.
Figure 2: Passenger side wiring harness after being relocated
Before installation of this header it is necessary to also open up the hole on the vertical
bracket on the rear of the header that bolts to the bell housing. Please note these bolts are
not in your car from the factory and you should use a pair of the manifold studs and nuts
for ease of install. The header on this side of the car is extremely close to the frame rail
and needs all of the room that it can get to move to the center of the car to prevent any
noise or rattles once install is completed.
Figure 3: Vertical bell housing mounting bolts (factory manifold studs can also be used)