LG Motorsports Man Knob - Manual (Page 5)

Assembly:
Now that you have the center console out of the vehicle, it is time to route the wiring for the man switch knob.
You will start by pulling down the fuse panel cover in the front of the passenger side foot well (See figure 9).
Next, using the fuse removal tool located in the fuse panel, remove the lower right most 10amp fuse (See
figure 10) Once the fuse is removed, plug the end of the longer harness that is included with your man switch
knob (looks like a fuse) into the fuse slot with the wires going to the left (See figure 11). Next route the wiring to
the upper left corner of the passenger foot well and tuck the wiring in behind the carpet next to the center
tunnel towards the shifter (See figure 12).
Figure 9 Figure 10
Figure 11 Figure 12
Once you have the longer harness routed from the fuse box, you can replace the cover on the fuse panel. Now
it is time to run the knob wiring. Start by feeding the wires through the shifter boot. Next hold the wires so that
they are on the passenger side of the center console, and set the center console loosely back in place (See
figure 12). Next you want to connect the wires from the knob to the wires coming from the fuse box and tuck
them under the carpet. At this point, all that is left is to put everything back together. Start by reconnecting all of
the wiring for the accessories in the center console. Then snap the center console back into place. Next,
Replace the 2 T15 Torx screws in the front of the console compartment, and replace the 2 nuts in the rear of
that compartment. Replace the fastener covers. Next replace the passenger side trim panel and 2 screws, and
snap the parking brake boot back into place.
10A Fuse
Fuse Removal Tool