LG Motorsports Slick Sand Primer Info for LG Hood Painting User Manual
Page 2
a division of Illinois Tool Works Inc. | 6600 Cornell Road | Cincinnati, OH 45242 | (513) 489-7600
Made and Printed in the U.S. | ©2009 Evercoat
evercoat.com
PREPARATION:
Pre-Painted Surfaces
Sand repair area and featheredge using 180 grit, 220 grit and finish with 320
grit sandpaper on a random orbital sander
Final clean with a quality wax and grease remover to remove sanding
residue prior to applying Slick Sand
Body Filler or Putty
Finish sanding body filler or putty with 180-220 grit sandpaper
Featheredge with 320 grit sandpaper
Blow off the surface with an air blow gun
MIXING:
Shake and stir thoroughly before mixing
Add one tube (.75 fl. oz.) liquid hardener to one quart of Feather Fill or 2% by
weight and mix thoroughly
Pot Life is 45 minutes @ 75°F (24°C)
Do not leave product in the spray gun for longer than 30 minutes
APPLICATION:
Use a primer gun with a 2.0 or larger fluid nozzle/air cap (Spray at paint gun
manufacturer’s recommended air pressure)
Apply 2-3 medium wet coats allowing 10-15 minutes flash time between
coats
FINISH:
Slick Sand will be ready to sand in about 2 hours depending on film build
Applying over self-etch primer could add 4-6 hours to the dry time
Once dry, sand Slick Sand with 400-600 grit sandpaper prior to next step
TECHNICAL
SPECIFICATIONS:
Appearance
Gray liquid
VOC
Packaged: 2.54 lbs/gal (305 g/L)
Applied: 1.72 lbs/gal (206 g/L)
Dry-Film-Thickness (DFT)
4.0
– 6.0 mils per coat
Solids by Volume
57-62%
Solids by Weight
71-74%
Viscosity (Ready to Spray)
30-35 seconds in Zahn #3
Coverage at 1 mil 100% Transfer
1200 sq. ft. per U.S. gallon
SAFETY &
HANDLING:
IMPORTANT: The contents of these packages must be mixed with other components before the
products can be used. Before opening the packages, be sure to understand the warnings on all
labels of all components since the resulting product will have the warnings and cautions of all its
parts. Improper spray technique may result in hazardous conditions. Follow the spray
equipment manufacturer's instructions to prevent injury or fire. Follow respirator manufacturer's
directions for respirator use. Always wear eye and skin protection. Observe all precautions.
Consult MSDS for further safety information and/or handling instructions. In case of emergency,
contact your local emergency room or poison control center immediately. For professional use
only. Material Safety Data Sheets can be found online @ evercoat.com.