Lingenfelter L650070105 Lingenfelter C6 Corvette Air Intake 2005-2007 v3.1 User Manual
Page 7
Page 6 of 7
Thoroughly clean edge of airbox with supplied alcohol pad.
Cut the supplied foam seal to fit airbox as shown in image. In-
stall rubber seal to three edges of airbox as shown. Make sure
the foam seal does not interfere with the mounting holes.
Slide airbox and filter assembly in place as shown.
Place the remaining 90-110 mm clamp on the hump hose and
connect the 4.0” hump hose to the throttle body. Push the
hose firmly as shown to seat the hump hose onto the throttle
body. Make sure the bottom is butted up to the throttle body
flange. Tighten the clamp securely.
Attach the breather hose to the plastic nipple in the hump
hose at this time.
For hood clearance reasons, the breather hose should be
clocked as close to the throttle body motor as possible.
Use four of the supplied push lock plastic rivet fasteners to
secure the airbox flange to the shroud. Pinch pieces together
as tight as possible while securing the fasteners.
From underneath the vehicle, starting with the bottom, center fastener, install the remaining seven supplied push
lock plastic fasteners, pinching pieces tight together while fastening.
Look at the air filter from underneath at this time, if it is not parallel with the cut in the shroud, it may be
straightened now.