Lingenfelter L650090206 Lingenfelter C6 Z06 Corvette Air Intake 2006-2013 v3.04 User Manual
Page 3
Read the entire instruction manual before beginning installation. Some stock
parts will be used in reassembly.
This air intake kit requires re-calibration of the factory engine management
software. If you do not have a way to re-calibrate the engine control module
(ECM), do not install this system until you are able to do so.
The installation of the LPE C6 Z06 High Flow Air Intake Kit requires the
modification of the fan shroud. If you do not feel comfortable with performing the
modifications to your shroud that are listed in this instruction manual or you would
prefer to keep the existing shroud in stock form, LPE offers an already modified
production GM shroud (PN: 10346001M
)
. Contact LPE or your LPE distributor.
WARNING: Installing the MAF sensor tube in the wrong direction is known to
cause drivability problems and/or the P0101 Diagnostic Trouble Code (DTC).
Make sure that the arrow on the MAF sensor is pointed in the direction of the air
flow (towards the engine).
Page 2 0f 9
• Disconnect battery ground.
• Remove gray retaining clip on the bottom side of the
MAF sensor, then disconnect MAF sensor connector.
• Disconnect breather tube from bellows.
• Loosen hose clamp at throttle body, pull bellows from
the throttle body.
• Work entire assembly free from push pins & remove
assembly from car.
• Remove four screws holding top mount radiator shroud
& unclip hose from top mount radiator shroud.
• Remove top mount radiator shroud.
• Disconnect electrical connector for under hood light &
unclip electrical connector for under hood light from the
radiator shroud.
• Disconnect the electrical connector from the outside air
temperature sensor located low on the right side of the
shroud.
• Remove the two “Christmas tree” push fasteners
holding the radiator shroud to the condenser (save the
fasteners for reuse). They are located approximately
midway up along each side.
• Raise front of vehicle, follow manufacturer instructions.
Use jack stands to support vehicle.