Lingenfelter L650060505 Lingenfelter Pontiac GTO Air Intake 2005-2006 v4.0b User Manual
Page 9
Step 24 - Remove the air filter from its packaging. This
filter comes pre-oiled and is ready to be installed. Filter
maintenance kits are available through LPE.
NOTE: Inspect inside of filter for any debris prior to
installing in the vehicle.
Step 25 - Install the filter as shown. Make sure the filter
is sealed on the air tube with the metal tube fully in-
serted into the rubber air filter neck. Tighten the clamp.
Step 26 - Reinstall the stock airtube by first plugging in
the MAF connector. Reinstall the grey retaining clip at
this time.
Step 27 - Push the airtube coupler firmly onto the 4.0”
tube assembly. Push the airtube onto the throttle body.
On the airbox side, position the tube assembly to maxi-
mize the clearance between the tube assembly and the
power steering pulley. Now tighten both clamps.
Page 8 of 10
CAUTION:
Be very careful when handling the Mass
Air Flow (MAF) sensor. Do not dent, puncture or
otherwise damage the Honeycell located at the air inlet
end of the MAF. Do not touch the sensing elements or
allow anything (including cleaning solvents and
lubricants) to come in contact with them. Do not drop
or roughly handle the MAF.