Lingenfelter L650080105 Lingenfelter PP C6 Corvette Air Intake Instructions v3.02 - Manual (Page 6)

Page 5 of 7
Install the 3.9” straight hose on the other side of the MAF
sensor.
Slide a 90-110 mm clamp over the straight hose section and
position the clamp as shown.
Slide another 90-110 mm clamp over the straight hose section
and attach the supplied plastic air-bridge to the other end
of the 3.9” hose with the nipple on the hump hose in the 10
o’clock position as shown.
Do not tighten the 90-110 mm clamp at this time.
Note position of logo on the air-bridge. As shown in the image,
the side of the plastic air-bridge that is closest to the LPE logo
(and not the Lingenfelter text) is the side that gets inserted
into the 3.9” hose.
Remove the protective cover from the LPE supplied air filter.
NOTE: Inspect inside of filter for any debris prior to installing
in the vehicle. Be very careful during the remainder of the
installation process to not let any dirt or objects fall into the
filter.
Install the 100-120 mm clamp on the rubber neck of the air
filter.
Supporting the bottom of the air filter with one hand, insert
the end of the air tube assembly (“air-bridge”) into the rubber
neck of the air filter.
Snug (not tighten) clamp.