Lock'er Down Model LD 2011E - Manual

Instructions for Model 2011 E with USB extension
1. If you have a combination lock, it is easier to set the
combination before installing the safe.
2. Open console and remove rubber pad in the floor of console.
3. There are 4 screws holding down the console, remove all four.
4. Put the lid assembly in as shown in Fig 1, turn and pull up to top.
5. Put in right side plate sliding it under USB cable and attach nuts.
6. put in left side plate and attach nuts.
7. Finally place connector strap between front and rear plates and
tighten all fasteners.
Enjoy your purchase.
Top Assembly Right Side Plate Left Side Plate