Lodar 16 Function Receiver/Actuator 12 Volt with master - Manual (Page 2)

Control Rod
Control rod setup on a popular carrier showing
air cylinder in an ideal mounting position
Chassis
Support Channel across vehicle
Co
ntr
o
l L
e
v
e
r
Control Lever
Housing
Simple to fit
One weld and one bracket
Bracket
Weld
Simple to pipe
P ush fit pipes to cylinder - colour coded
Connect blue pipe to the air supply
THE ACTUATOR
Cylinder
SPECIFICATIONS
The Actuator Assembly
Air Cylinder(s) 32mm(1.25") bore x 50mm(2") stroke
Fitted with trunnion and clevis, with lug(s) ready for welding
2 push fit elbows per cylinder
The Receiver/Control Box
Radio Receiver with outputs to valves - prewired
Flow control valve
3ft lengths of output pipe with push fit connections to the cylinder(s) - colour coded for each pair of functions.
6ft length blue supply pipe fitted with 1/4" adaptor (push fit)
8ft twin core power supply cable
Max air pressure
120psi
Air requirements Must be CLEAN and DRY (air flow is minimal)
Max push 149 lbs @120psi
Max pull 128 lbs @120psi
Voltage 12 and 24 Volts available (24 Volt systems are suffixed 24 – e.g. 92 1 50/24 etc)
Lodar, 12189 State Highway 148 S, Henrietta, Texas. 76265 – Tel: 1 877 257 1581 – Fax: 1 763 431 2520
WILL IT FIT
325mm (12.8”) approx at Max Travel
FOR RADIO SPECIFICATION SEE – s92 1 04 and s92 1 06
64mm
(2.5”)
Trunnion for
approx
cylinder mounting
IMPORTANT MEASUREMENT when mounting
270mm (10.6”) approx with Cylinder at mid point
Lug for clevis
at cylinder rod end
Allow a minimum of 6mm (1/4”) clearance over dimensions shown