Luxul XGS-1008 - Manual (Page 8)

User Guide
8 © Copyright 2014 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
3. PREPARING FOR INSTALLATION
3.1 System Requirements

Ethernet Cables to connect the XGS-1008 to Ethernet enabled devices

Power should be AC 100-240V~ 0.1A(Max) 50/60Hz.
3.2 Installation Requirements

Install the XGS-1008 in a stable/safe place to avoid any possible damage

Inspect the AC power cord to ensure that it is correctly connected and
undamaged

To avoid electric shock, DO NOT open the XGS-1008 housing (no user service-
able parts inside). Opening the XGS-1008 will void your warranty.

It is recommended that the Grounding connection to the outlet is functioning
properly and the XGS-1008 is positioned away from direct sun light

Ensure there is suffi cient space around the XGS-1008 for proper ventilation and
heat dissipation. It is recommended to have at least 4-6 inches around all sides.
3.3 Before Connecting to the Network
Before connecting the XGS-1008 to the network, please check the following:

Determine placement location. Do not place any heavy articles on the XGS-1008.

Ensure there is adequate space for proper heat dissipation and ventilation around
the XGS-1008.

Power socket should be within 4 feet of the XGS-1008.

Check power adapter to confi rm safe and secure connection.
4. XGS-1008 INSTALLATION
4.1 Connecting Devices
Use standard Ethernet CAT5, CAT5e or CAT6 cable to connect the XGS-1008 to
a device as described below (CAT6 must be used in order to achieve full Gigabit
bandwidth). The XGS-1008 will automatically adjust to the characteristics (speed/
duplex) of the device to which it is connected.