Luxul AMS-1208P - Manual (Page 6)

Quick Install Guide AMS-1208P
14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-QIG-AMS-1208P 1224140959
6
2
2
Rack-Mounting the AMS-1208P
„
Using the included screws, attach the mounting ears to each side of the switch.
„
Mount the switch in the rack with the LEDs facing outwards. Be sure the switch is
level and properly secured within the rack.
Desktop Setup
For use as a desktop device, position and apply the included rubber feet to the
bottom of the AMS-1208P.
2
2
Attaching the Rubber Feet to the AMS-1208P
Network Connections:
The AMS-1208P supports 10/100/1000 Mbps Ethernet; 10/100 Mbps half/full-
duplex mode and 1000 Mbps full-duplex mode. All RJ-45 ports support Auto MDI/
MDIX and can be used as ordinary ports or as Uplink ports. Any RJ-45 port can be
used to connect the AMS-1208P to an Ethernet enabled device (including servers,
routers, and other switches) without a crossover cable.
The AMS-1208P offers 2 Gigabit RJ-45 and 2 Gigabit SFP ports for expansion. This
allows for the use of standard Ethernet cable or Gigabit optical fi ber for network
expansion. If using optical fi ber, Gigabit SFP modules are required (Not Included).
Once the Gigabit SFP optical modules are inserted, these interfaces can support
optical fi ber cables to extend the Gigabit network—enabling the network to reach
beyond the 300 foot limitation of twisted pair Ethernet.
For the RJ-45 ports, Category-5, super Category-5 or Category-6 unshielded twisted
pair (CAT5/CAT5e/CAT6 UTP) should be used.