Simply connected, Installation preparation, Rear panel – Luxul XMS-1010P User Manual
Page 5: System and environmental requirements, Network ports
Simply Connected
© 2015 Luxul. All Rights Reserved.
Other trademarks and registered trademarks are the property of their respective owners
5
Network Ports
f
There are 8 10/100/1000Mbps RJ-45 ports (Ports 1~8).
f
Two Gigabit ports (that support Auto MDI/MDIX).
NOTE:
When powering up, the port LEDs corresponding to the optical
interface may take a moment to initialize. This is normal as the
XMS-1010P does not detect the optical connection until after the
initialization and startup of internal software systems are completed.
NOTE: The XMS-1010P has an internal 130W power supply. For optimal
switch performance, it is recommended that maximum combined
power usage of external PoE devices does not exceed 115W.
Rear Panel
The rear panel provides an AC input socket and power on/off switch. Use the included
power cable to connect the XMS-1010P to a surge protected outlet. The built-in high-
performance switching power supply of the XMS-1010P supports an input range of: AC 100 ~
240V, 50/60Hz 1.7A.
INSTALLATION PREPARATION
System and Environmental Requirements
f
Network cables to connect the XMS-1010P to Ethernet enabled devices
f
A computer supporting TCP/IP and equipped with a Web browser. Supported Web browser
versions include Microsoft IE 9.0 and up, Safari 5.0 and up or Mozilla Firefox 3.6 and up, Chrome
6.0, Opera 10.6 and up. The Web browser is used to configure the XMS-1010P.
f
Power must be AC 100 ~ 240V, 50/60Hz 1.7A.
f
Temperature of the operating environment should be: 32F~113F (0C~45C). Place the switch away
from heat generating devices. For best performance and heat dissipation/ventilation, make sure
there is adequate space around the switch.
f
Humidity of the operating environment should be: 5%-95% non-condensing. Do not place the
switch in an extremely dirty or damp location.
f
Keep the switch away from strong electromagnetic fields (i.e. Air Conditioner compressors, fluores-
cent light ballasts, CRT monitors/televisions, etc.), and free from vibration, dust and direct sun light.