Magnepan MG 3.6 - Manual (Page 14)

17. MG3.6/R SPECIFICATIONS
SYSTEM DESCRIPTION: 3-Way True Ribbon Tweeter, Planar-Magnetic Midrange and
Bass with Bi-Amplification Option
BASS SECTION: 500 Sq. In. Planar-Magnetic
MIDRANGE SECTION: 199 Sq. In. Planar-Magnetic
TWEETER SECTION: 5/32 Inch Width, 55 Inches Long FREQUENCY RESPONSE:
**34Hz to 40kHz ±3dB
POLAR RESPONSE - RIBBON DRIVER: 180° Horizontal dispersion both front and
back to 20kHz
RECOMMENDED POWER: 75 to 250 Watts RMS (8 Ohm rated). SENSITIVITY:
86dB, 500Hz, 2.83Volts
IMPEDANCE: Bass- 4.7 Ohms
Midrange/Ribbon Tweeter- 4.2 Ohms Ribbon Tweeter- 3.3 Ohms
CROSSOVER: Crossover between bass and midrange is 200Hz
Crossover between midrange and tweeter is 1700Hz
DIMENSIONS: 24'W X 71"H X 1-5/8"D
WARRANTY: Limited. Non-transferrable - Ribbon Foil Element - 1 Year
Balance of Speaker - 3 Years
SHIPPING WEIGHT: 145 Lbs. With Accessory Package
*Because there are no universally accepted methods for loudspeaker measurement,
frequency response specifications may be stated by most manufacturers without
reference to measurement techniques and/or specific locations in rooms. Magneplanar
loudspeaker frequency response curves are minimum average performance levels that
may reasonably be expected in normal installations.
**New Magneplanar MG3.6/R speakers will not display their full bass potential. After a
month or two of use the bass response will lower 5Hz or more. At this point the
response will stabilize and the speakers rated performance (or better) can be realized.
While this 5Hz or more of lower bass response is important, the most important factors
in obtaining good bass response from the MG3.6/R speakers are room size and
geometry, wall material, and speaker placement.