Magnepan MG 3.7 - Manual (Page 5)

6. Hookup
The 3.7i features unique, high current connectors which provide optimum
contact area with the speaker cables up to 10 gauge (or for banana connectors).
Simply strip 1/2" of insulation from the end of the cable. Insert the cable into
the terminal (observing polarity), and tighten the set screws with the Allen
wrench provided. Banana plug connectors can be used and locked in place
with the set screws. Spade lug adapters are available from your Magneplanar
dealer for spade connectors that are incompatible with the Magneplanar high
current connector.
7. Caution
The terminal plate states a maximum fuse value of 5 amps Type 3AG
(“normal” or “fast blow”) for the midrange and 2 1/2 amps for the tweeter. The
bass section does not require fusing protection. This fuse value should never
be increased or bypassed. Do not use slow-blow fuses. BURNED OUT
MIDRANGE OR TWEETERS ARE NOT COVERED UNDER THE
WARRANTY.
8. Speaker Placement
Proper speaker placement and room acoustics can have a greater effect on a
music system than upgrading one of the components in the system.
Unfortunately, there is no definitive guideline which will cover all possible
listening rooms. Some experimentation is required for locating the optimum
position. The following are a few general guidelines:
Revised 2-27–2015 Page of 5 9