Marsh Sound Design The HT 4000 High Resolution Audio-Video Processor - Manual (Page 10)

QUICK
SET
UP
10
Compression
Status Display
This is used to lower the dynamic so you can
listen at low volume and still here the
dialog. This doest give the best sound it is
only meant for vary low volumes.
1, to turn on compression press 7
when in the main menu. Off or on will
blink press select it is on then press exit
add the compression will be set?
2. To turn off do the same thing till off
is blinking
This function turns on and off the automatic on
screen status display. When on, automatic
when you press the volume up or down the
status shows on screed
1. To change press 8 and on/off will
blink press select till the desired on or off
is blinking then press exit this will set the
command.
DVD Audio Full Range
Rest To Defaults
This sets analog bass management for the
7.1 audio input. When in full range (yes)
there is no filters or HI pass filters. When set
for full range (no) the filters will be set by
your speaker set up and subwoofer yes no
menu
This will set the unit to all factory defaults,
we recommend not to use this unless there is
trouble with any of the setting you have
done then this is good way to get the unit
back out of the box condition. This is used
whenever there is an up date to the unit
firmware
1. Press 0 on the remote when in the
main menu (no) will blink, press select
to toggle no to yes then press exit and
the command will set.
Marsh Sound Design